I need to remove a desk

I need to remove a desk

When removing a desk, start by identifying the sensor attached to the desk so you can look it up.

Once you've done that, go to ADMIN and Sensors, and click the small pencil icon next to the sensor.

Then select 'More edit options' and click Deactivate. Follow the dialog. It takes a little time to deactivate, so please be patient.











After removing the desk, consider whether your floor plan needs to be updated.

Save battery: When the sensor has been taken down, it's a good idea to store it near a Cloud Connector. This prevents it from entering booster mode and helps save battery life.

    • Related Articles

    • How do I remove a sensor from a desk?

      The sensor is attached with strong adhesive. So when you want to remove a sensor from a desk, you need to use a putty knife or similar tool and give the sensor a gentle push with it. IMPORTANT: When you push the sensor off, you must do so by pushing ...
    • I need to move a desk

      When physically moving a desk, start by identifying the sensor attached to the desk so you can look it up. Once you've done that, go to ADMIN and Sensors, and click the small pencil icon next to the sensor. Then choose which location the sensor ...
    • I have installed a new desk

      When you have a new desk that you want to monitor, you need to assign a sensor to it. Take an unused sensor from the drawer—either a new one or one you have taken down from another desk and deactivated. Find the sensor’s ID by holding your phone over ...
    • I need to set up one or more sensors. How do I do this?

      First and foremost, there is the system part of a setup. You can read about that here. Then there is the physical part, which we describe here. The sensor should be placed 2-4 cm from the front edge of a desk approximately in the middle of the ...
    • I need to find and identify a sensor

      If you're holding a sensor and, for some reason, don’t know where it belongs, you need to locate and identify it in the system. You can do this in one of two ways: Open the camera on your phone and point it at the QR code on the sensor. This will ...