I have installed a new desk

When you have a new desk that you want to monitor, you need to assign a sensor to it. Take an unused sensor from the drawer—either a new one or one you have taken down from another desk and deactivated.

Find the sensor’s ID by holding your phone over the QR code, then locate it in the list of inactive sensors under ADMIN and Sensors.

When you find the sensor, there will be a small lightning bolt icon next to it. Click it, give the sensor a name, select the correct location, and click Activate.

Next, place the sensor on the floor plan. You do this under ADMIN and Locations. Click the small pencil icon next to the location and select the FLOOR PLAN tab. The sensor will now be visible on the right-hand side in the ‘Sensors’ box, and you can drag it directly onto the floor plan.

Note!
If you have a new floor plan, please read the section ‘New floor plan.’

IMPORTANT! When installing a new desk with a sensor, remember to assign the sensor the relevant tags.

• Related Articles

• I need to move a desk

  When physically moving a desk, start by identifying the sensor attached to the desk so you can look it up. Once you've done that, go to ADMIN and Sensors, and click the small pencil icon next to the sensor. Then choose which location the sensor ...

• I have a new floor plan

  If your floor plan has been updated, you can replace it in the system under ADMIN and Locations. Select the location and then the FLOOR PLAN tab. At the bottom of this page there is a button called CHANGE BACKGROUND IMAGE. IMPORTANT! Before you ...

• I need to remove a desk

  When removing a desk, start by identifying the sensor attached to the desk so you can look it up. Once you've done that, go to ADMIN and Sensors, and click the small pencil icon next to the sensor. Then select 'More edit options' and click ...

• How do I remove a sensor from a desk?

  The sensor is attached with strong adhesive. So when you want to remove a sensor from a desk, you need to use a putty knife or similar tool and give the sensor a gentle push with it. IMPORTANT: When you push the sensor off, you must do so by pushing ...

• We are behind on updating desks and sensors. How do we clean this up?

  Find a quiet time when there are no employees at the affected desks/areas. Go there and take one desk at a time. There can be different scenarios for each desk that has not been updated with the correct information: A sensor is missing. Install a new ...