I have a new floor plan

I have a new floor plan

If your floor plan has been updated, you can replace it in the system under ADMIN and Locations. 



Select the location and then the FLOOR PLAN tab. At the bottom of this page there is a button called CHANGE BACKGROUND IMAGE.

IMPORTANT! Before you change the floor plan: A floor plan must always be 1024x768 pixels and in .png format. Since most buildings don't have exactly that aspect ratio, there will normally be a need to insert some white space either to the right of or below the floor plan. This is done for example in Photoshop or Pixelmater.

To avoid having to move all the dots around on the drawing every time you get a new floor plan, it is important that you crop the drawing the same way every time. Find for example a corner to start from.

InfoNOTE! Changing a floor plan requires that you are used to working with images. If you don't feel completely comfortable trying it yourself, you are always welcome to contact us at IoT Fabrikken.

    • Related Articles

    • I have installed a new desk

      When you have a new desk that you want to monitor, you need to assign a sensor to it. Take an unused sensor from the drawer—either a new one or one you have taken down from another desk and deactivated. Find the sensor’s ID by holding your phone over ...

    • I need to move a desk

      When physically moving a desk, start by identifying the sensor attached to the desk so you can look it up. Once you've done that, go to ADMIN and Sensors, and click the small pencil icon next to the sensor. Then choose which location the sensor ...

    • I have reallocated desks from one department to another

      There are two approaches, depending on whether you want to move the desks physically or just assign them to another group: If you have physically moved the desks, you also need to move them on your floor plan. You do this by following the guide on ...

    • Working with tags

      Tags are an easy way to identify a group of desks with shared characteristics. By using tags, you can easily extract data for specific types of workspaces. These can include department names, sub-departments, executive areas, and so on. Tags can also ...

    • I need to set up one or more sensors. How do I do this?

      First and foremost, there is the system part of a setup. You can read about that here. Then there is the physical part, which we describe here. The sensor should be placed 2-4 cm from the front edge of a desk approximately in the middle of the ...