IoT Fabrikken - Knowledge Base

Help Center
RoomAlyzer - Space Management
Help Articles Related to Our Space Management Products
RoomAlyzer – Indoor Climate
Articles Related to Indoor Climate Measurement

Recent Articles
Display Data on an External Screen
With just a few clicks, the RoomAlyzer system can generate an external link that lets you display selected data wherever you need it — for example, on a tablet or a large screen in the reception area, classroom, meeting room, or office. This allows ...
Grouping sensors – locations
If you have many sensors, it’s a good idea to group them so that those physically located near each other can also be viewed together in the system. To group your sensors, go to ADMIN, Locations. Click +CREATE in the upper right corner and give your ...
I have reallocated desks from one department to another
There are two approaches, depending on whether you want to move the desks physically or just assign them to another group: If you have physically moved the desks, you also need to move them on your floor plan. You do this by following the guide on ...
I need to set up one or more sensors. How do I do this?
First and foremost, there is the system part of a setup. You can read about that here. Then there is the physical part, which we describe here. The sensor should be placed 2-4 cm from the front edge of a desk approximately in the middle of the ...
How do I remove a sensor from a desk?
The sensor is attached with strong adhesive. So when you want to remove a sensor from a desk, you need to use a putty knife or similar tool and give the sensor a gentle push with it. IMPORTANT: When you push the sensor off, you must do so by pushing ...

Popular Articles
Deviations
The RoomAlyzer system continuously compiles statistics on which of your indoor climate values deviate from your defined thresholds. This means you can always see your biggest challenges when it comes to indoor climate. You can view your deviations by ...
Article for Testing
Article for Testing
Creating users
You can easily create a new user in the RoomAlyzer system. Do this by selecting ADMIN, Users. On the Users page, you’ll see 4 tabs: Basic Information Settings Which locations are shown on the start page? Access Info: Usually, you only need to fill ...
Deactivating a sensor
You can access and edit your sensor information by selecting ADMIN, then Sensors, and clicking the pencil icon next to the desired sensor. If you need to temporarily deactivate your sensor and plan to use it again later, choose more options and click ...
Move a Sensor and Delete Data
You can edit information about your sensor by selecting ADMIN, Sensors, and clicking the pencil icon next to the sensor you want to modify. If you want to move your sensor to a new location—and wish to begin data collection from scratch—simply ...

Help Center